I need a printable 3D model of a specific car, built strictly from the reference photos I will supply (front, side, and rear views). The final mesh must focus on a high level of exterior detail — accurate body lines, trim, lights, badges, and panel gaps—while remaining a single, watertight shell. Scope • Exterior only. No interior or under-hood geometry. • Solid windows and lights; they should read clearly once printed but remain part of the same body shell. • A flat chassis plate incorporated under the body, pre-aligned for separate wheel parts. Leave simple cylindrical pins or holes so I can snap-fit the wheels later. • Scalable for printing anywhere between 1:43 and 1:12. If you work 1 mm = 1 cm in CAD that’s fine; just supply overall dimensions so I can rescale accurately. Deliverables 1. Car body + integrated flat chassis in a single watertight STL. 2. Separate STL (or multiple STLs) for the four wheels, matching the mounting interface you created. 3. A quick screenshot or turntable render confirming key details before final export. Technical expectations • Clean topology, no non-manifold edges, intersecting faces, or flipped normals. • Wall thickness suited for SLA/FDM printing—if unsure, assume minimum 0.8 mm for smaller prints. • All parts positioned at world origin, oriented flat to the build plate. I’ll review an initial low-res proof to confirm proportions, then you can finalize the high-detail mesh. If additional angle shots are required, just tell me early so I can capture them. Looking forward to a precise, print-ready model that does justice to the real car.