I need a clean, filament-efficient 3D model for a Ruijie Reyee RG-EW1200 router mount. It must print in PLA without supports and hold the device vertically. Key specs • Open-face, claw-style band that lets the router slide straight down from above. • Internal width 80 mm. • Internal depth 23.5 mm at the top, tapering to 22 mm at the bottom. • Back plate thickness ≥ 2 mm; claws up to 4 mm for strength. • Two wall-mounting holes sized for 4 mm countersunk screws. • Entire geometry printable in one piece on a typical 180 × 180 mm bed with no supports. Deliverables 1. Editable CAD file (STEP or Fusion 360 preferred). 2. Print-ready STL. 3. Brief notes on print settings you recommend for PLA. I’ll test-fit the first print and provide feedback; a quick iteration may be needed to perfect the taper and slide-fit.