I need a seasoned Fanuc programmer to write and optimise G-code for a milling machine running complex plastic parts. I will supply the 3D model or drawing; you translate it into clean, collision-free code that runs first time. Key points • Machine: Fanuc-controlled milling centre • Material: plastic, so chip evacuation, low heat, and burr-free edges matter • Part geometry: complex pockets, contours, and multiple tool changes Deliverables • Production-ready G-code • A concise setup sheet listing tool numbers, offsets, feeds & speeds • One round of tweaks after my first test run Keep cycle time efficient without compromising surface finish. Let me know which CAM software you prefer, examples of similar work, and an estimate of hours needed per part so I can plan slotting on the shop floor.